Installation Guide

GGF600AV
0"
Minimum
to cabinets
below
cooktop
30"
(see note)
18"
30"
16" max
to cabinets
above
counter
6" Right side
6" Left side
Minimum
to side wall
36"
30"
24"
12 3/8"
Side Wall
Gas
and
electrical
supply
Note: Minimum to bare cabinet above;
see Installation Instructions for alternate
installation congurations.
30"
Note: Rear
wall to front
of door glass.
25 1/2"
w/o handle
27 7/8"
with handle
47 1/2"
10 3/4"
36" to
36 1/2"
3 1/4"
6 1/2"
14 1/2"
GE
®
30" Free-Standing Gas Convection Range with No Preheat Air Fry and EasyWash
™
Oven Tray
Dimensions and Installation Information (in inches)
Provide adequate clearances between the range and adjacent
combustible surfaces. These dimensions must be met for safe
use of your range.
Allow 30" (76.2 cm) minimum clearance between burners and
bottom of unprotected wood or metal cabinet, or allow a 24" (61 cm)
minimum when bottom of wood or metal cabinet is protected by no
less than 1/4" (6.4 mm) thick ame-retardant millboard covered with
no less than No. 28 MSG sheet metal (.015" [.38 mm] thick), .015"
(.38 mm) thick stainless steel, .025" (0.64 mm) aluminum or .020"
(0.5 mm) copper.
Installation of a listed microwave oven or cooking appliance over
the cooktop shall conform to the installation instructions packed
with that appliance.
For island installation, maintain 2-1/2" minimum from cutout to
back edge of countertop and 3" minimum from cutout to side
edges of countertop.
Before installing, consult installation instructions for current
dimensional data and additional requirements.
Electrical Rating: 120V, 60Hz, 13A
Breaker Size: 15A
All GE Appliances ranges are equipped
with an Anti-Tip device. The installation
of this device is an important, required
step in the installation of the range.
For answers to your Monogram, Café
™
, GE Profile
™
or GE Appliances
product questions, visit our website at geappliances.com or call
GE Answer Center
®
Service, 800.626.2000.
Specication Revised 5/24