Quick Start Manual

4
Installation Preparation
PREPARE ELECTRICAL WIRING
WARNING
FOR PERSONAL SAFETY: Remove house
fuse or open circuit breaker before
beginning installation. Do not use an
extension cord or adapter plug with this
appliance.
ADVERTENCIA
ADVERTENCIA PARA SEGURIDAD
PERSONAL: Quite el fusible o abra el
interruptor de circuitos antes de comenzar
la instalación. No utilice un cable de
extensión o un enchufe adaptador con
este artefacto.
Electrical Requirements
•This appliance must be supplied with 120V, 60Hz., and
connected to an individual properly grounded branch
circuit, protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
•Wiring must be 2 wire with ground.
•If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
Grounding Instructions—Cable Direct
This appliance must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and be
connected to the equipment grounding terminal or lead on the
appliance.
Grounding Instructions—Power Cord Models
This appliance must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the risk of
electrical shock by providing a path of least resistance for
electric current. The plug must be plugged into an appropriate
outlet that is installed and grounded in accordance with local
codes and ordinances.
WARNING
The improper connection of the
equipment grounding conductor can
result in a risk of electric shock. Check
with a qualified electrician or service
representative if you are in doubt that the
appliance is properly grounded.
ADVERTENCIA
La conexión inadecuada del conductor de
conexión a tierra del equipamiento puede
provocar un riesgo de descarga eléctrica.
Consulte a un electricista calificado o
representante de servicio técnico si tiene
dudas sobre la correcta conexión a tierra
del aparato.
Cabinet Preparation & Wire Routing
•The wiring may enter the opening from either side,
rear or the floor within the shaded area.
•Cut a 1-1/2” max. dia. hole to admit the electrical cable. The
hole must be free of sharp edges. If the cabinet wall is metal,
the hole edge must be covered with a bushing.
•Cable direct connections may pass through the same hole as
the drain hose and hot water line, if convenient. If cabinet wall
is metal, the hole edge must be covered with a bushing.
NOTE: Power cords with plug must pass through a separate
hole.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dishwasher .
•For cable direct connections the cable must be routed as
shown in Figure 5. Cable must extend a minimum of 24”from
the rear wall.
•For power cord connections, install a 3-prong grounding type
receptacle. The power-supply receptacle for the appliance
shall be installed in a cabinet or on a wall adjacent to the
undercounter space in which the appliance is to be installed.
Figure 5
White
24"
from Wall
3"
from
Cabinet
Ground
Black
1-1/2" Dia.
Hole (Max.)