Installation Guide

ManualsBrandsGE ManualsAppliance partsDishwasher Third Rack Accessory Kit

FOLLOW THE LINK BELOW TO ACCESS AN

INSTRUCTIONAL VIDEO FOR INSTALLING THE

3RD RACK:

http://www.geappliances.com/qr/dishwasher/thirdrack/

Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com

31-31588 05-18 GEA

COMPATIBLE WITH THESE GE APPLIANCES DISHWASHER MODELS:

GDF530PGM, GDF530PSM, GDF530PMM, GDT605PGM, GDT605PSM,

GDT605PMM, GDT605PFM, GDT605PBM, GDP615HSM, GDP615HFM,

GDP615HBM, GDT635HSM, GDT635HMM

Built-In Dishwashers

Installation

Instructions

3rd Rack Installation

BEFORE YOU BEGIN

Read these instructions completely and carefully.

FOR YOUR SAFETY

Read and observe all WARNINGS shown throughout

these instructions.

While performing installations described in this booklet,

gloves, safety glasses or goggles should be worn.

IMPORTANT – Observe all governing codes and ordinances.

• Note to Installer – Be sure to leave these instructions

for the consumer’s and local inspector’s use.

• Note to Consumer – Keep these instructions with

your Owner’s Manual for future reference.

• Skill Level – Installation of this kit requires basic

mechanical skills. Proper installation is the

responsibility of the installer. Product failure due

to improper installation is not covered under the

GE Appliances Warranty. See Warranty information.

IMPORTANT NOTES

• This kit is for use with GDF530PGM, GDF530PSM,

GDF530PMM, GDT605PGM, GDT605PSM, GDT605PMM,

GDT605PFM, GDT605PBM, GDP615HSM, GDP615HFM,

GDP615HBM, GDT635HSM, GDT635HMM models only.

• This 3rd Rack cannot be used on plastic tub

dishwashers produced before 2018.

• Use a #2 Phillips-head screwdriver to drive all screws.

• Power tools should not be used during the installation of

the 3rd Rack.

• Torque higher than 15 inch pounds will strip the screw

boss.

• The 3rd Rack mount can temporarily support its own

weight with its locator. It CANNOT support the weight

of the rails until screws are driven.

• Consider lowering the upper rack to the lower option

after installing the 3rd Rack

• All the front end hooks of the rails should be pointed

upwards.

• If, at the last step, there is interference between the

3rd Rack and the upper rack, make sure that the

mounts are properly seated against the ceiling of the

tub and

the screws are driven in completely. If the issue

persists,

lower the upper rack to the bottom setting.

• If cup shelves are installed on the upper rack, they should

be removed prior to 3rd Rack installation and use.

TOOL YOU WILL NEED:

#2 Phillips-head screwdriver

IMPORTANT: Do NOT use any power tools

to drive the 3rd Rack screws.

PARTS INCLUDED:

• Mounts (2)

• Rails (2)

• Screws (4)

• 3rd Rack

Tray Assembly (1)

• Rear End Caps (2)

Printed in the United States

READ CAREFULLY - KEEP THESE INSTRUCTIONS

The rail end caps can be a choke

hazard for small children if removed

from the dishwasher. Keep out of reach of children.

WARNING

Summary of content (12 pages)

PAGE 1
Built-In Dishwashers Installation Instructions 3rd Rack Installation COMPATIBLE WITH THESE GE APPLIANCES DISHWASHER MODELS: GDF530PGM, GDF530PSM, GDF530PMM, GDT605PGM, GDT605PSM, GDT605PMM, GDT605PFM, GDT605PBM, GDP615HSM, GDP615HFM, GDP615HBM, GDT635HSM, GDT635HMM Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com FOR YOUR SAFETY BEFORE YOU BEGIN Read these instructions completely and carefully.
PAGE 2
Installation Instructions 3 INSTALL 3RD RACK MOUNTS 1 REMOVE UPPER RACK • Insert the locating tab of the 3rd Rack mount into the tub slot and fully seat against the ceiling of the tub. • Be sure the tub mount is flush with the side wall of the tub. • Part will temporarily retain itself in the tub until screws are installed. • Align the screw holes and use a Phillips screwdriver to drive one of the provided screws into each screw hole. DO NOT USE POWER TOOLS OR OVERTIGHTEN.
PAGE 3
Installation Instructions 5 INSTALL 3RD RACK INTO RAILS 7 RE-INSTALL UPPER RACK • Fully extend both 3rd Rack rails. • Tilt the front of the 3rd Rack tray assembly upwards and place its rear wheels just behind the front end hooks. Tilt front up • Fully extend the upper rack rails. • Tilt upwards the front of the upper rack and place the rear rack rollers over the front end hooks. • Push the upper rack along the rails until the front rack rollers clear the front end hooks.
PAGE 4
Notes 4
PAGE 5
Lave-vaisselle intégrés Installation du 3e panier Instructions d’installation COMPATIBLE AVEC LES MODÈLES DE LAVE-VAISSELLE GE APPLIANCES SUIVANTS : GDF530PGM, GDF530PSM, GDF530PMM, GDT605PGM, GDT605PSM, GDT605PMM, GDT605PFM, GDT605PBM, GDP615HSM, GDP615HFM, GDP615HBM, GDT635HSM, GDT635HMM Des questions? Appelez GE Appliances au 877-994-5366 ou visitez ElectromenagersGE.ca/fr AVANT DE COMMENCER: Lisez ces instructions en entier avec attention.
PAGE 6
Instructions d’installation 1 RETIRER LE PANIER SUPÉRIEUR 3 INSTALLERLES MONTURES DU 3e PANIER • Tirez le panier supérieur vers l’extérieur à sa pleineextension. • Soulevez le panier de façon que les roulettes frontales se dégagent des crochets à l’extrémité avant sur chaque glissière latérale. • Tirez le panier vers l’extérieur jusqu’à ce que les roulettes arrière touchent les crochets d’extrémité avant sur chaque glissière. • Soulevez le panier hors des glissières.
PAGE 7
Instructions d’installation 5 INSTALLER LE 3e PANIER DANS 7 RÉINSTALLER LE PANIER LES GLISSIÈRES SUPÉRIEUR • Tirez les deux glissières du 3e panier à leur pleine • Tirez les glissières du panier supérieur à leur pleine extension. • Soulevez le devant du plateau assemblé du panier et placez ses roulettes arrière juste derrière les crochets d’extrémité frontaux. Soulever le devant extension.
PAGE 8
Notes 4
PAGE 9
Lavavajillas Incorporados Instalación del 3er Estante Instrucciones de Instalación COMPATIBLE CON ESTOS MODELOS DE LAVAVAJILLAS DE GE APPLIANCES: GDF530PGM, GDF530PSM, GDF530PMM, GDT605PGM, GDT605PSM, GDT605PMM, GDT605PFM, GDT605PBM, GDP615HSM, GDP615HFM, GDP615HBM, GDT635HSM, GDT635HMM ¿Preguntas? Llame a GE Appliances al 800.GE.CARES (800.432.2737) o visite nuestro sitio Web en: GEAppliances.com ANTES DE COMENZAR: Lea estas instrucciones en su totalidad y atentamente.
PAGE 10
Instrucciones de Instalación 1 RETIRE EL ESTANTE SUPERIOR 3 INSTALE LOS MONTANTES DEL 3er ESTANTE • Empuje el estante superior hacia afuera hasta alcanzar su • • • • extensión total. Levante el estante de modo que las ruedas delanteras despejen los ganchos del extremo frontal de los rieles a cada lado. Empuje el estante hacia afuera hasta que las ruedas traseras tengan contacto con los ganchos del extremo frontal de los rieles a cada lado. Levante el estante fuera de los rieles.
PAGE 11
Instrucciones de Instalación 5 INSTALE EL 3er ESTANTE EN LOS 7 VUELVA A INSTALAR EL ESTANTE RIELES SUPERIOR • Extienda completamente ambos rieles del 3er Estante. • Extienda completamente los rieles del estante superior. • Incline hacia arriba el frente del estante superior y coloque las ruedecillas del estante trasero sobre los ganchos del extremo frontal. • Empuje el estante superior a lo largo de los rieles hasta que las ruedecillas frontales del estante despejen los ganchos del extremo frontal.
PAGE 12
Notas 4