Installation Guide

Installation Instructions
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT
NOTICE
STEP 1 REMOVE POWER FROM
DISHWASHER
• Unplug the dishwasher.
• Feed power cord back into its storage location.
STEP 2 REMOVE UNICOUPLE FROM
FAUCET
7XUQRႇKRWZDWHU
• Relieve water pressure from the unicouple assembly
before disconnecting it from the faucet by depressing the
red pressure relief button on the unicouple.
• Depress the locking collar and remove the unicouple from
the faucet.
• Drain excess water from the unicouple by holding it below
sink level and allowing excess water to run from the
hoses into a pan or similar container to catch the water.
• Feed the unicouple and hoses back into their storage
pocket.
STEP 3 STORE DISHWASHER
• Close the dishwasher door.
• Roll the dishwasher into its storage location.
Depress collar to
release unicouple
from faucet
Depress red button to
release water pressure
• If the sink is 34" or higher from the floor, the excess
water in unicouple hoses cannot be drained directly into
the sink. It will be necessary to drain excess water from
hoses into a bowl or suitable container that is held outside
and lower than the sink.
HOW TO DISCONNECT DISHWASHER
Appliance Park
Louisville, KY 40225
STEP 3 CONNECT THE UNICOUPLE
TO THE FAUCET
• Run garbage disposer, if you have one, to clean out the
disposer and thus allow water to drain from the sink
through the disposer and down the drain.
• Run hot water faucet to purge cold water from the hot
water line. The hot water must be between 120°F and
150°F for best wash performance.
• Roll the dishwasher to a position just in front of the sink.
• Pull the unicouple and its hoses completely out from
storage compartment at rear of the dishwasher.
• Attach the unicouple to the
faucet adapter following
the three steps below:
– Depress the locking
collar at the top of the
unicouple.
– Place the unicouple
completely over the faucet
adapter.
– Release the locking collar. The unicouple should now be
locked onto the faucet adapter.
• Turn on the hot water faucet and check for leaks. If a leak
is detected, disconnect the unicouple, and refer to Step 4.
NOTE: The unicouple’s small hose carries water from the
faucet to the dishwasher. The large hose carries water from
the dishwasher to the sink. Orient the faucet with the
unicouple attached so water from the unicouple will run into
the sink drain.
STEP 5 PRETEST CHECK LIST
Review this list after connecting your dishwasher to avoid
charges for a service call that is not covered by your
warranty.
 Open the door and remove all foam and paper
packaging.
 Locate the Owner’s Manual.
 Read the Owner’s Manual to familiarize yourself with the
operation of the dishwasher.
 Remove the protective film, if present, from the control
panel, door and cabinet.
 Add 2 quarts of water to the bottom of the dishwasher to
lubricate the pump seal.
 Plug power cord into outlet.
 Close and latch dishwasher door.
 Start dishwasher.
STEP 4 FAUCET ADAPTER LEAK
Skip this step if no unicouple leak was observed.
If a unicouple leak was observed in Step 3, take whatever
actions are necessary to repair the leak. This may be as
simple as tightening the faucet adapter. Or, it may require
the services of a plumber if water is leaking from the
interface between the moveable faucet arm and the fixed
part of the faucet fastened to the sink.
Collar