Manual

About the displaydiagnosticcodes.
iLii_ _i ii _
iiii!(i ii( iiii i_iiii i
ii(i iii iii _i/
iiiiii_ i__ii i ii
i_i_ iii_ii i i I
What/t Means What ToDo
Not enough water is
entering the dishwasher.
OR
The drain pump could be
temporarily blocked
(usually caused by food
I)nlalch the door. If there is no water in
the bouom of d_e dishwasher, check the
wamr supply to the dishwasher.
Is lhe dishwasher waler supply lumed on?
Is lhe household waler supply lurned on?
If you use well or cistern wa|er, is d_e
supply adequate?
If the water supply is adequate, uy the
_ycle again. If E5 repeats, call for seisqce.
I)nla|ch the door. If there is standing
waler in the bonom of the dishwasher,
relatch the door, touch START, then
,_t;1 h M_v_=c.essuc..ascere_,.
immedialelv touch RESETIo start the
pump. If E5 conlinues to appear, you
may need to do this several times to
break up the blockage.
i/! ii iii
i i i_i i ii
ii ii
The water temperature
in the dishwasher did not
reach the proper wash
temperature. This is
usually caused by lack of
hot water coming from the
household water heater.
The temperature sensor
L. I in the dishwasher is not
functioning properly.
Dishwasher may condnue
to be used, but itwiR not
heat water automatically.
Avoid showers or laun&y,just prior to
running the dishwasher. (Use the
DEtAg SYARY feature to start dishwasher
when the water hea_er is up to normal
mmperamre.) Adjust household
waler healer fl]ennostat/o 120 °F.
minimum.
If E_ appears wid_ eve U tycle and you
know the water flom the water hearer is
h()t (1_0°F. (1imore), call tOTsei_qce.
The temperature sensor needs to be
replaced. Call for sei_ice.
NOTE"You may continue to use your
dishwasher. For best resuhs a(!jusl your
household wa|er healer thermostat
to 140 °F.
/4
Before YouCall For Service
TIT the (y(le again t(/see ifthe (ode reappears. The dishwasher may
conect itself.
Elecnonic connols can be aflecmd by outside interlerence. Shutting off
power to the dishwasher (at the tuse or ciivuit breaker) could conect
lhe problem. Restore power after 15 seconds and/1T the tycle again.
Check the g_aide tOTthings you can do t15toneel the problem.
See the Tmubleshootin.q_psat the back of this manual.