Installation guide

continued
[Step15 Connect power supply
Verify that power isturned offat source. If power cordis
used, plug itintothe wall outlet and go to Step 16. If dish-
washer isto be directly wired to house wiring, continuewith
this step.
Remove junction box cover.
Secure the power supply cable to the back of the junctionbox
with a strain relief (notsupplied).
WARNING
If house wiring is not 2-wire with a ground wire,
a ground must be provided by the installer.
When house wiring is aluminum, be sure to use U.L.Listed
anti-oxidant compound and aluminum-to-copper connectors.
Locate the three dishwasher wires (white, black, and green)
with the stripped ends. Insert the three wires through the
small hole in the junction box bracket. Using wire nuts of
appropriate size, connect incoming ground to green wire,
white to white and blackto black, as shown in Figure U.
Replace the junction box cover. Check to make sure that wires
are not pinched under junction box cover.
White
Neutral
Gro!_ \ _
.... .Black
__ Live FigureU
I I Note:CheckThat
HarnessLeadsAre
ThreadedThruSmall
HoleinBracket
Step16 Pre4est check liSt
[] Checkto besure power is off. [] Pull lower rack about halfway out. Check to be sure it does
[] Open dishwasher door and remove all foam and card- not roll back intodishwasher or further out. If it does,
board packaging.
[] Remove literature package with Use & Care manual.
[] Read the Use & Care manual to familiarize yourself with
the operation of the dishwasher.
[] Add two quarts of water to the bottom of the dishwasher
to lubricate the pump seal.
[] Remove the protective film if present from the control
panel, access panel and door panel.
[] Checkto be sure that wiring is secure under the dish-
washer, and not pinched or in contact with door springs or
other dishwasher components.
relevel dishwasher.
[] Turn on water supply.
[] Check for plumbing leaks. lighten connections if
necessary.
[] Check that door spring does not contact water line, fill
hose, wiring or dishwasher components.
[] Turn on the hot water faucet at the sink and verify water
temperature. Water going to dishwasher must be between
the temperatures of 120°Fand 150°E
[Step 17 Dishwasher wet test check list
[] Turn on power supply. [] Check for leaks around the door. A leak around the door
[] Latch door.
[] Select normal cycle on push-button or electronic models.
[] On dial models, turn control dial just enough to start
dishwasher. Be careful notto turn the dial past the first
water fill. On electronic models, push start pad.
[] Check to be sure that water enters the dishwasher. This
could take upto 4 minutes.
If water does not enter the dishwasher, check to be sure
that water is turned on.
[] Check for leaks under the dishwasher. If a leak is found,
turn off power supply, tighten connections and restore
power.
could be caused by dishwasher door rubbing or hitting
against adjacent cabinetry. Reposition the dishwasher if
necessary.
[] The dishwasher will drain about 5 minutes after the first fill,
Check drain lines. If leaks are found, turn off power, correct
as necessary and restore power.
[] Open dishwasher door and make sure most of the water
has drained. If not, checkthat disposer plug has been
removed and/or air gap is not plugged.
[] Let the dishwasher run through another fill and drain cycle.
Check again to be sure there are no leaks.
[] Atthe end ofthe second drain, push the reset pad on
electronic models. Ondial models, unlatch the door and
rotate the dial to the "OFF" position.