Installation guide

continued
Step 7 Positionwaterline and power supply
Position the water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Line Supply
FigureL
Step 8 "se.drain hosethroughcabinet
Upright dishwasher and position in front of the cabinet
opening. Insert the drain hose into the hole previously drilled in
the cabinet wall. If a power cord is used, guide the end
through a separate hole cut for the electrical cord.
Power cord should be routed directly to the rear of junction box
avoiding contact with spring or other dishwasher components.
_!ater
Figure M
/
Step8A InstallTrimPieces (onsomemodels)
• Press the trim onto the tub flange on each side of the
dishwasher. Start even with the top edge and press in as
you move to the bottom.
• Press trim piece onto top dishwasher flange.
• Open and close the door to checkthat trim does not bind.
Note:Tub trim is located in
dishwasher upper rack.
lStep9 Slidedishwasherintocabinet J
Slide the dishwasher into the opening a few inches at a time.
As you proceed, pull the drain hose through the opening and
under the sink. Make sure drain hose is not kinked under
dishwasher. Check to be sure there is no interference with
water line and wiring.
DONOTPUSH
AGAINSTFRONT
DOORPANEL
WITH YOUR
KNEE.Damageto
the doorpanel
will occur.
FigureN
Step10 Alignwater and electrical lines j
Routethe water line and
electrical supply to their
connection locations
under the dishwasher.
Do not connect water
and electrical in this step.
RearView
Step 11Leveldishwasher ]
Level the dishwasher by adjusting the
four leveling legs individually for correct
alignment. See Figure O.
Dishwasher should be level left to right
and front to backfor proper dish rack
operation and dishwasher performance.
Dishwasher door should be in alignment
with adjacent cabinets. See Figure P.
@
Figure0
Step12 Positiondishwasher and fasten to cabinet]
Openthe door and position the dishwasher tub flange 3/4"
from the cabinet opening. Fasten the dishwasher to the
underside of the countertop, using the 2 Phillips screws
provided in Step 1. Be sure screws are driven straight and
flush to avoid interference with door operation. See Figure P.
Important:
Make sure that /_
dishwasher is
centered in the
opening and
there is no
interference with
cabinets when
opening or closing
the door. Interfer-
ence may cause a
water leak when
dishwasher is in
operation.
Figure P