Installation Guide

Dishwasher Installation
Check the electrical connection to the water
valve. The red electrical connector should be
plugged into the dishwasher water valve. If it is
not plugged in, turn off electrical power to the
dishwasher. Plug the red connector into the dish-
washer water valve and then restore power.
Check for leaks under the dishwasher. If a leak is
found, turn off power, tighten connections and
restore power.
Check for leaks around the door. A leak around
the door could be caused by the dishwasher door
rubbing or hitting adjacent cabinets. Reposition
the dishwasher if necessary. See Steps 11, 12
and 13.
Most dishwasher models will drain about 3 min-
utes after the rst ll. Check the drain line for
leaks when dishwasher drains. If leaks are found,
turn off power, correct as necessary and then
restore power.
Open the dishwasher door and make sure most
of the water has drained. If the water does not
drain, check to be sure disposer plug has been
removed and/or air gap is free of debris.
Let the dishwasher run through another ll and
drain cycle. Check again to be sure there are no
leaks.
At the end of the second drain, unlatch the door
and rotate the dial to the “OFF” position.
14
STEP 19: DISHWASHER WET TEST
CHECK LIST
Turn on power supply or if power cord is used,
plug it into the wall outlet.
Latch dishwasher door.
Press the “Normal” pad, and then turn control dial
just enough to start dishwasher. Be careful not to
turn the dial past the rst water ll. Dial should
point to “Hot Start Option”.
Check to be sure that water enters the dish-
washer. This could take up to 4 minutes.
If water does not enter the dishwasher try the
following to correct the problem:
– Check to be sure that the water is turned on
– Lightly tap the ood oat cover to
dislodge a stuck ood oat.
Flood Float
Cover
Appearance varies by model.
Red Connector
Pots
&Pans
Cycles
Options
Hot Start
Option
Start
Off
Plate Warmer
(Heated Dry On)
Rinse Only
(Heated Dry Off)
Light Wash
Normal
Wash
Heated
Dry
Reset
Option