Installation Instructions

Dishwasher Installation
12
CONNECT DRAIN LINE
(CONT.)
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure
hose with a screw-type clamp.
Method 1 – Air gap with waste tee or disposer
Method 2 – “High drain loop” with waste tee or
disposer
Fasten drain hose to underside of countertop with a
hanger.
IMPORTANT – When connecting drain line to
disposer, check to be sure that
drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges for a
no drain complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose
in the dishwasher cavity from becoming kinked or
crushed by the dishwasher.
CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8” through 1”
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port.
• Cut drain hose connector on the marked line, if required,
to fit the inlet port.
• If a longer drain hose is required, and you did not
purchase the GPF10S drain hose, add up to 42” length,
for a total of 120” (10 feet), to the factory- installed
hose. Use 5/8” or 7/8” inside diameter hose and a
coupler to connect the two hose ends. Secure the
connection with hose clamps.
IMPORTANT: TOTAL DRAIN HOSE LENGTH MUST
NOT EXCEED 10 FEET FOR PROPER DRAIN
OPERATION.
Cutting Line
1"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
STEP 15 STEP 15
Hose
Clamp
Coupler Hose
Clamp
Waste Tee Installation Disposer Installation
18"
Min.
32"
Min.
Drain Hose Hanger
Waste Tee Installation
18"
Min.
32"
Min.
Drain Hose Hanger
Disposer Installation
Remove
Drain
Plug