Installation Guide

20
REMOVE THE FREEZER DOOR
Remove the freezer door top hinge cover (if
equipped) by either squeezing it and pulling it
up or by prying it off with a plastic putty knife.
Remove the two 5/16” hex head screws, then
lift the hinge straight up to free the hinge pin.
Open the freezer door to 90.°
Installation Instructions
DISCONNECT THE POWER COUPLING
(on some models)
If the refrigerator has a water dispenser,
there is a power line (harness) from the cabinet
into the bottom hinge on the freezer door that
must be disconnected.
To disconnect, pull apart at the coupling.
4
Bottom
freezer
hinge
DISCONNECT THE ELECTRICAL
CONNECTORS (on some models)
If the refrigerator has a refreshment center,
there are electrical connectors (harnesses)
from the cabinet into the bottom hinge on the
refrigerator door that must be disconnected.
To disconnect, pull apart each connector.
5
Bottom
refrigerator
hinge
CLOSE THE FREEZER AND
REFRIGERATOR DOORS
6
7
A
C
B
5/16” Hex Head
90°
MOVING THE REFRIGERATOR (CONT.)