Manual

Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
• CAUTION - Unplugthe
refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips Pliers
screwdrivers
1/4" Nutdriver or adjustable wrench
Sharp knife
i-i-I PREPAREFOR INSTALLATION
, Remove and discard the large white plug from the
rear freezer wall.
, Remove the outlet cover with u flat-blade screwdriver.
[-3-]INSTALL THE ICEMAKERFILL CUP
Install the icemaker fill cup (side-mounted) (15) into the
icemaker as shown.
m PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker power
cord plug into the socket, making sure that the prongs
and holes are matched. Press the plug firmly into the
socket. Lock the plug in place by clipping the restraints
onto each side of the plug. Make sure the restraints click
into place. Make sure the power cord is still in the hook on
the back of the icemaker.
Hook
[_] MOVE FEELERARM TO THE STOP
POSITION
Move the feeler arm to the STOP (up) position. Leave the
feeler arm in the STOP position until the refrigerator is
connected to the water supply to prevent premature
operation.
(Appearance may vary)
D MOUNT THE ICEMAKER
, Lift the icemaker so the
fill tube extension (8) fits
in the fill cup opening (C).
Hang the icemaker on the
two mounting screws (A).
Hake sure: .....
• The power cord is still
firmly in the socket.
, The fill tube extension (8) is still in the fill cup opening,
(Check the rear of the refrigerator to make sure the
fill tube has not been pushed out of the back of the
refrigerator.)
,The icemaker mounting screws are located in the
uppermost position of the mounting slots.
, The icemaker is level.
THEN TIGHTEN THE ICEMAKER MOUNTING SCREWS
SECURELY,
13