Installation Guide

Installation Instructions

200mm & 300mm (Round signal)

Installation Steps:

1. Verify input voltage is within specified range on the back of the LED signal module before installation. Failure

to do so will cause lamp to fail.

2. Open front cover of (customer supplied) traffic signal housing.

3. Remove outer lens and incandescent bulb from traffic signal housing OR existing LED signal module. Retain all

hardware as removed as it may be needed in subsequent steps.

NOTE: Installer is responsible for ensuring the disposal of removed components complies with all applicable

regulatory requirements.

4. Ensure that a gasket is present around the perimeter of the new LED signal module.

5. Insert the LED signal module into the available cavity from previous LED module or incandescent bulb.

6. NOTE: Ensure that the arrow () on the back cover of the LED signal module is oriented pointing up.

7. Install mounting hardware to ensure that the LED signal module is securely fastened to traffic signal housing.

8. Connect the white wire to the neutral terminal block and the colored wire to the positive, supply voltage

terminal block.

9. NOTE: Ensure that the correct wire is securely connected to correct terminal block for proper operation.

10. After installation of all modules is complete, ensure all traffic signal housings are closed and secured properly.

11. Apply power and ensure proper operation of traffic signal modules per intersection requirements as specified

by customer.

…Page 2

Risk of Electric Shock

Install unit in enclosure tested

to be suitable for wet locations

only.

GTx Round Module – 200mm

GTx Round Module– 300mm

Voltage Rating

Up arrow ()

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Prepare Electrical Wiring

Electrical Requirements

 Do not use in wet locations

 Follow all National Electric Codes

(NEC) and local codes.

WARNING / AVERTISSEMENT

Risk of Electric Shock. Disconnect Before Servicing or installing product.

Risque de choc électrique. Couper l’alimentation avant le dépannage ou avant

l’installation du produit.

PAGE 1
Installation Instructions 200mm & 300mm (Round signal) Prepare Electrical Wiring BEFORE YOU BEGIN Read these instructions completely and carefully. Electrical Requirements   Do not use in wet locations Follow all National Electric Codes (NEC) and local codes. WARNING / AVERTISSEMENT Risk of Electric Shock. Disconnect Before Servicing or installing product. Risque de choc électrique. Couper l’alimentation avant le dépannage ou avant l’installation du produit. Installation Steps: 1.
PAGE 2
Installation Instructions (cont’d) This product is intended solely for the use of traffic signaling and is not intended for use in any other applications NOTE: If you prefer to have this Installation Instructions document in other languages, visit our official website at: www.gelighting.com/installation GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com 1-888-69-43-533 • or • +1.216.266.2419 GE Lighting Solutions, LLC is a subsidiary of the General Electric Company.