Quick specs

GUD27EESN GUD27GESN
GE
®
Unitized Spacemaker
®
3.9 DOE Cu. Ft. Stainless Steel Washer and 5.9 Cu. Ft. Dryer
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
Specification Revised 4/19
For answers to your GE Profile
™
Series or GE Appliances product questions, visit our
website at geappliances.com or call GE Answer Center
®
Service, 800.626.2000.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
ELECTRICAL REQUIREMENTS:
GUD27EESN Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to
the frame. Power cord should be purchased separately.
GAS REQUIREMENTS:
GUD27GESN Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical
service and should be protected by 20-amp time-day fuses or circuit
breakers. This appliance is equipped with a 4-foot long flexible U.S.
listed 20-amp power cord to match a 20-amp receptacle.
NOTE: Gas Rated input 20,000 BTU/HR. Factory equipped for natural
gas. Tested for LP gas. LP gas supply requires a conversion kit. Have a
qualified gas technician install a conversion kit before use.
Dryers must be exhausted to the outside.
INSTALLATION INFORMATION: For complete information, see
installation instructions packed with the product.
Installation Instructions
* Dimension represents door closed including handle and knobs.
NOTE: With feet set at mid position, feet can be adjusted +/- 3/8".
27" NOMINAL PRODUCT DIMENSIONS
Vent
Drain outlet
51°
Water Inlets
(rear)
(rear)
*26-1/8"
34-3/8"4-3/8"
18-5/8"
13-1/4"
75-7/8"
53-1/4"
3-7/8"
36-7/8"
30-7/8"
26-3/4"
22-1/4"
Gas Inlet
(Rear view of appliance)
3"
3"
47 1/2"