Installation Guide

5
Installation Instructions
Step 5. Flush Filter
1.Ifyouhavenotalreadydoneso,installthefilter
tothemanifold.Oncethesystemisinstalled,turn
onthewatersupplyandcheckforleaks.(Ifaleak
occursatfitting,repeatstep4.Ifaleakoccurs
aroundthefilter,removeandreinstallthefilter
canister[seestep6].)
2.Cyclethewaterdispenserorrunoptionalvalvefor
6gallons(flushapproximately10minutes)toflush
outanyharmlesscarbonfinesthatmaybepresent.
3. Turn on the icemaker.
4.Writethedateonthefilterandalsomarkyour
calendartoreplacewithanotherfilteraftersix
months.
OPTIONAL VALVE
Anoptionalvalvecanbeinstalledtoflushwater
withoutgoingthroughthewaterdispenser.(Thisvalve
mustbepurchasedseparatelyandinstalledtocomply
withexistingstateorlocalplumbingcodes.)
Step 6. Replacing the Filter Canister
1. Turn off the icemaker.
2.Removethefiltercanisterfromthemanifoldby
rotating the canister to the left about 1/3 turn.
(*Note:Asmallamountofwaterfromthetubing
betweenthefilterandrefrigeratormaycomeout.
Asmalltowelshouldbeabletocatchit.)
3.Installthenewfiltercanisterintothemanifold
byturningittotherightabout1/3turnuntilthe
alignment marks line up and the filter stops.
DONOTovertighten.Thefilterwillraiseupasitis
turned.
4.Cyclethewaterdispenserorrunoptionalvalvefor
4gallons(flushapproximately5minutes)toflush
outanyharmlesscarbonfinesthatmaybepresent.
5.Turnontheicemaker.
6.Writethedateonthefilterandalsomarkyour
calendartoreplacewithanotherfilteraftersix
months.
Inlet
Outlet
To drain or
other container
Optionalvalve
To install Toremove