Product Manual

Replacement Procedures
8-24 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Rear cover removal
Follow these steps to remove the rear cover:
1. Remove two screws on each side of the Rear Cover.
2. Lift the Rear Cover away.
Rear cover installation
Follow these steps to install the rear cover:
1. Position the lower edge of the rear cover into place on the
rear of the Ultrasound system frame.
2. Tilt the top edge of the rear cover toward the Ultrasound
system frame.
Be sure the Z mechanism’s manual release handle extends
through the air vent on the rear cover.
3. Position the rear cover into place.
4. Gently pull up on the Z mechanism’s manual release handle
to confirm proper position through the rear cover air vents.
5. Install the four screws, two on each side. Install the two
lower screws first, then the upper screws.
6. Inspect the filter, and clean if necessary.
7. Install the filter.
8. Install the filter cover.
9. Install the rear bumper.
10. Install the side covers.
Verification
Perform the following steps to verify that the product is
functioning as intended after this replacement:
1. Connect cables and probes you removed earlier
2. Power up the Ultrasound system to verify that it operates as
intended.