Product Manual

GE HEALTHCAREDRAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5450839-100, REVISION 5 DRAFT (JANUARY 17, 2013) BASIC SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-31
BC Ensemble Out Of Range press ok and save this user-setting once again
BC lines_per_sequenz < 1 Action: restart the system restart the system
BC_Dynamic Out Of Range press ok and save this user-setting once again
BC_Gain Out Of Range press ok and save this user-setting once again
BC_Lines: BC_LineDensity out of limit restart the system
BCMC_Balance Out Of Range press ok and save this user-setting once again
bCP_ConvertParameters failed restart the system
bCP_ConvertParameters failed Action: restart the system,
If after restart not ok then call technical support
restart the system
bCP_ConvertParameters failed. Action: restart the system,
If after restart not ok then call technical support
restart the system
bCP_ProcessIQEnsemblePacket failed Action: restart the system,
If after restart not ok then call technical support
restart the system
bCP_ProcessIQMModePacket failed restart the system
B-DynContrast Out Of Range press ok and save this user-setting once again
BF: can't set BM RxApod restart the system
BF: can´t set C Rx Apod restart the system
BF: can't set D RxApod restart the system
binary file not found Action: restart the system restart the system
Binary path not set restart the system
BM_Resample: overrun SampleLengthOnLineMem restart the system
bPWCW_ProcessPWCWData in RT_PWorCWFilterBlock::bFilteredSamples
AddedToWorkingBuffer() returned error code xxx!!
Action: restart the system, If after restart not ok then call technical support
restart the system
Can not create test report data restart the system
Can not send test report check DÍCOM server configuration
cannot allocate memory restart the system
Cannot create instance restart the system
cannot open file restart the system
Cannot read a valid Probe-ID (xx) from Attempt to read Probe-ID from an invalid
probe connector. Action: restart system
restart the system, connect another probe
Cannot read a valid Probe-ID (xx) from left probe connector (A). Connect another probe
Cannot read a valid Probe-ID (xx) from middle probe connector (B). Connect another probe
Cannot read a valid Probe-ID (xx) from right probe connector (C). Connect another probe
Cannot read a valid Probe-ID (xx) from lower-left probe connector (CW). Connect another probe
Error Messages Actions