Product Manual

GE HEALTHCARERAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5450839-100, REVISION 5 DRAFT (JANUARY 17, 2013) BASIC SERVICE MANUAL
3-14 Section 3-5 - Connection of Auxiliary Devices
3-5-3 Connecting the Color Printer
1.) Power OFF/Shutdown the system as described in:
Section 3-6-3 on page 3-27.
2.) Connect the Color printer according to correct connection scheme as described in Figure 3-7 on
page 3-15
.
NOTE: The Color printer should be connected to the USB1 port of the Voluson® P8 / Voluson® P6´s PC-part.
3.) When all the cables are connected, press the Power ON switch on the Color printer.
4.) Power ON/Boot up the Voluson® P8 / Voluson® P6 system as described in
Section 3-6-2 on page
3-23
. All software drivers are pre-installed for the designated Color printer only.
5.) After physical connection to the Voluson® P8 / Voluson® P6 system, assign the printer to a remote
key (P1
, P2, and P3 ) as described in Section 3-7-6 "Remote Control Selection" on page 3-53.
6.) Verify the correct settings in the printer “Properties”, see: Section 3-7-5 "Adjustment of Printer
Settings" on page 3-46
.
WARNINGWARNING
!! WARNING:
After each installation, the leakage currents have to be measured according to
IEC 60601-1 respectively UL 60601-1.