Installation guide

Installation Instructions

[] ALIGNING THE WALL PLATE

CAUTION: Wear gloves

to avoid cutting fingers on

sharp edges.

oOo oOoOoOoO OoO, iOoOoOoOo OoOoOoOo o I

Area E Hole D

[]Draw a vertical line oil |he wall at tile cenler of tile

30" wide space.

[] Use lhe Inounfing plate as the template for tile rear

wall. Place the mounting plale on tile wall, Inaking

sore that tile tabs are touching the bottom of the

cabinet or the level llne drawn in Step C for cabinets

with front overlmng. Line up the notch and centerline

on the bottom of the mounting plate to the centerline

on the wall.

[] While holding Ihe mounting plale with one hand,

draw circles on lhe wall at holes A, B, C and D

(see illustralion above/actual plate, marked with

arrows). Four holes must be used for mounting.

[]

NOTE: Holes C and D are inside area E. If neilher

(] nor D is in a slud, find a stud somewhere in area E

and draw a fifth circle m line up wilh the stud. It is

iInporlant lo use at least one wood screw lnouIlled

firmly in a stud lo support lhe weight of the microwave.

Set the mounting plate aside.

Drill holes on the circles. If there is a stud, drill a :_"

hole fbr wood screws. For holes that don't line up with

a stud, drill a %" hole for toggle bolls.

NOTE: DO NOT MOUNT THE PLATE AT THIS

TIME.