GE Oil & Gas High Pressure Ratio Compression Innovative HPRC technology in a lightweight, compact and cost-efficient package
A whole new way of thinking about compression GE’s HPRC technology is based on an innovative architecture that combines unshrouded and shrouded impellers on a single highspeed shaft to achieve pressure ratios and efficiency levels higher than other available technologies. As result of the increased head per stage, HPRC units have a shorter bearing span that reduces the number of casings required. Applications that would typically require multiple compressor bodies will only need one with HPRC.
Smaller package Bigger results Comprehensive testing The rigorous validation program comprised a variety of tests on machine integrity, compressor performance, operability and response to upset conditions: • Full load compressor performance • Extensive rotor-dynamic test campaign • Aeromechanical test at different suction pressure levels • Test of upset conditions such as emergency shut-down and exploration of surge region
HPRC technology is applicable to many gas processes and is well suited to both low and medium molecular weight mixtures. It delivers high reliability and efficiency: from reduced weight and easier installation, to minimized footprint, lower power consumption and reduced maintenance. Highly compact HPRC has up to 50% smaller footprint and 30% lighter weight than traditional train configurations.
Optimized design The use of both unshrouded and shrouded impellers on a stacked rotor with hirth teeth allows high tip speed and eliminates the shrink-fit limitation typical of other centrifugal compressors. Head per stage has been increased and the number of stages reduced by about 50%. The result is a higher total pressure ratio with fewer impellers. equivalent parallel shaft gear.
GE Oil & Gas geoilandgas.com/HPRC Global Headquarters The Ark 201 Talgarth Road, Hammersmith London, W6 8BJ, UK T +44 207 302 6000 customer.service.center@ge.com The information contained herein is general in nature and is not intended for specific construction, installation or application purposes. GE reserves the right to make changes in specifications or add improvements at any time without notice or obligation.