Installation Guide

10 49-60698-3
Installation Instructions
2
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
3
INSTALL THE MOUNTING
SCREWS
Ɣ Skip to Step 4 if screws are already in place in
the freezer side wall.
Ɣ Install two self-tapping
Phillips head screws (10)
from the kit in the holes in
the side wall. The screw
heads should extend about
1/2" (13 mm) from the side
wall.
4
INSTALL THE ICEMAKER
FILL CUP
Install the icemaker fill cup (end-mounted)
that came with your unit into the icemaker as
shown. If the fill cup has been misplaced, call
1.800.626.2002 and order part WR29X10092.
ICEMAKER INSTALLATION INSTRUCTIONS
T
- IM4D ONLY
1
PREPARE FOR INSTALLATION
Ɣ Remove the storage
basket (on some models)
by pulling it out to the
stop position and lifting it
up and out.
NOTE: After removing
the basket, push the
extension arms back into
the freezer compartment.
Ɣ5HPRYHWKHFKLOOHUVKHOI
(on some models) by
pulling it straight out.
Ɣ5HPRYHWKHFHQWHU
vertical shelf support (on
some models) by lifting it
and rotating its bottom to
the right.
Ɣ,QVLGHWKHIUHH]HU
remove the two small
white plug buttons
(on some models)
from the side wall. (If
screws are present
instead of plugs,
leave them in place.)
Ɣ5HPRYHDQGGLVFDUG
the large white plug
from the rear freezer
wall.
Ɣ5HPRYHWKHRXWOHWFRYHUZLWKDIODWEODGH
screwdriver.
Flat blade and Phillips
screwdrivers
Pliers
Sharp knife
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
TOOLS YOU WILL NEED
Outlet
cover
Remove side wall plug buttons
or leave screws in place
Rear wall
plug button
Power
Switch
(Appearance may vary)
INSTALLATION INSTRUCTIONS