Installation Guide

12 49-60698-3
Installation Instructions
1
REMOVE THE COVER
Remove the compressor compartment access
cover. This requires removing screws which
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access
cover must be reinstalled later to ensure your
refrigerator will function properly.
2
ATTACH THE WATER VALVE
Ɣ/RFDWHWKHIHPDOH
connector plug.
Plug the female
connector (C) onto
the male terminals
on the water valve
(3). Either wire
can go on either
terminal.
Ɣ)DVWHQWKHZDWHU
valve to the
cabinet by driving
the hex-head
screw (9) from the
kit into the hole in
the cabinet leg.
CAUTION
Some models have multiple screw
holes on the cabinet leg. Be sure not to use the
same screw hole as the access cover, and that the
water valve does not interfere with other components
or wires in the compressor compartment, as this may
cause damage.
WATER VALVE INSTALLATION INSTRUCTIONS
U V
OR
W
Flat blade and Phillips
screwdrivers
Pliers
Sharp knife
Are these the right instructions for your model? Follow the Installation Instructions indicated by the
label on the back of the refrigerator -
U V
or
W
. For letter
T
, go to page 14 for instructions.
TOOLS YOU WILL NEED
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
1/4" and 5/16" Nutdrivers
C
3
9
INSTALLATION INSTRUCTIONS