Installation Guide

49-60698-3 13
INSTALLATION INSTRUCTIONS
3
CONNECT WATER TUBE
TO INLET
Ɣ6TXHH]HWKHHQGVRIWKHhose clamp (14)
from the kit with pliers and slide the clamp over
the fill tube assembly, located in the top right
corner of the refrigerator.
Ɣ:KLOHVWLOOVTXHH]LQJWKHFODPSLQVHUWWKH
free end of the water tube (3) into the fill tube
assembly as far as it will go.
Ɣ7KHQVOLGHWKHFODPSGRZQZDUGWRFDSWXUHWKH
water tube in place.
Ɣ8VLQJRQHRIWKHadhesive-backed fasteners
(4), secure the water tube to the back of the
refrigerator about 1/2" below the inlet.
Ɣ,IWKHZDWHUWXEHLVQRWSXVKHGLQDVIDUDVLW
can go and the hose clamp is not in place over
the fill tube assembly, then leaks are possible.
14
4
Fill tube
assembly
Water tube
Clamp
3
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
(Continued)
4
INSTALL WATER LINE CLAMP
Ɣ$WWDFKWKHmetal water
line clamp (strain relief)
(6) to the refrigerator.
Drive the screw (5) from
the kit through the clamp
(6) at the small indent into
the back of the cabinet.
Ɣ7KHPHWDOFODPSLVIRUWKHKRXVHZDWHUOLQH
(see the Water Line Installation Instructions).
It is not to be used for the water tube from the
water valve up to the inlet.
5
ROUTE AND ATTACH THE
WATER TUBE
Ɣ)DVWHQWKHSODVWLFZDWHUWXEHWRWKHEDFNRIWKH
refrigerator with adhesive-backed fasteners
(4), spacing the fasteners as shown to take up
slack in the tube.
5
6
Small indent for water
line clamp installation
Adhesive-backed
fasteners for water tube
6
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
7
REINSTALL THE COVER
Reinstall the compressor compartment access
cover. This requires using the screws you
removed previously to reattach the cover to
the back of the refrigerator case. This must
be reinstalled for your refrigerator to function
properly.