Installation Guide

14 49-60698-3
2
PLASTIC WATER TUBING
Ɣ5HPRYHZDWHUOLQHIURPWKHYDOYHDVVHPEO\
(3) included in this kit by removing the tube
from the clip and pushing on the bottom of the
valve quick-connect, disengaging the tube and
pulling it from the valve.
Ɣ8VHWKHZDWHUOLQHIURPWKHILOOWXEHDVVHPEO\
that came with the refigerator. The water line
is attached to the fill tube assembly that is
already installed in the refrigerator. Remove
the plug from the end of the waterline. Route
the water line through the clip on the valve
pushing it into the quick-connect on the valve.
The white line will
be barely visible
if properly
engaged.
1
REMOVE THE COVER
Use a 5/16" nutdriver or an adjustable wrench
to remove the compressor compartment access
cover. This requires removing six screws which
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access
cover must be reinstalled later to ensure your
refrigerator will function properly.
3
ATTACH THE BRACKET
EXTENSION TO THE WATER
VALVE
Ɣ8VHD´
nutdriver to
attach the
bracket extension
(16) to the water
valve bracket
with the screw
(17).
WATER VALVE INSTALLATION INSTRUCTIONS
T
- IM4D ONLY
Flat blade and Phillips
screwdrivers
Pliers
Sharp knife
TOOLS YOU WILL NEED
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
1/4" and 5/16" Nutdrivers
Installation Instructions
Push up
Quick-connect
Pull down
Clip
Water line
Quick-connect
Clip
Water line
Bracket
extension
17
16
INSTALLATION INSTRUCTIONS