Installation Guide

49-60698-3 15
INSTALLATION INSTRUCTIONS
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
(Continued)
4
ATTACH THE WATER VALVE TO
THE MACHINE COMPARTMENT
Ɣ/RFDWHWKHIHPDOHFRQQHFWRUSOXJ3OXJWKH
female connector onto the male terminals on
the water valve. Either wire can go on either
terminal.
Ɣ)DVWHQWKHZDWHUYDOYHWRWKHFDELQHWE\GULYLQJ
the hex-head screw (9) from the kit through the
hole in the bracket extension and into the hole
in the cabinet.
5
INSTALL WATER LINE CLAMP
Ɣ$WWDFKWKHwater line
clamp (6) (strain relief)
from the kit to the
refrigerator. With the
clamp directly in line with
the water valve, drive the
screw (5) from the kit
through the clamp at the indent into the back
of the cabinet.
Ɣ7KHPHWDOFODPSLVIRUWKHKRXVHZDWHUOLQH
(see Water Line Installation Instructions). It is
not to be used for the tubing from the water
valve up to the icemaker.
6
ROUTE AND ATTACH THE
PLASTIC WATER LINE
Ɣ)DVWHQWKHSODVWLFZDWHUOLQHWRWKHEDFNRIWKH
cabinet with adhesive-backed fasteners (4).
9
5
6
Adhesive-backed
fastener for plastic
water line
4
7
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
8
REINSTALL THE COVER
Reinstall the compressor compartment access
cover. This requires using the screws you
removed previously to reattach the cover to
the back of the refrigerator case. This must
be reinstalled for your refrigerator to function
properly.