Manual

[] 4-Wire ConduitInstallation
I_.emove tile 3 screws tl'onl tile c()nrlector block. Rernove tile p-rotnldin_,-straD
ti'om the connector block middle location and tile screw c()nrlecting it to the
ti'ame ot tile range. Insert bare wires between the connector block terminals
and movable trots. Tighten screws securely. Attach ground wire to the ti'ame ot
the rano-e
WARNIN&Connoctorblockis approvodfor copporwiroconnoction
only. ff aluminum wire is used, soo note below.
NOTE."ALUMINUM WIRING
Do llOt Collnect altlrnirll.nll wire to cormector block,
Use copper building wire rated tor the correct amperage and vohage to
make 3 (three) 3" copper jumper wires. Connect wire as per Step 6 or 7
depending on number ot wires.
Splice copper wires to aluminum wiring usir N special connector terminals
(lesigned and U1:approved tor ioining copper to ah]rnirmm and tollow the
connector manutacturer's recommended procedure closely.
Wireused locationandenclosureof splicesetc mustconformtogoodwiringpractices
andlocalcodes
_sre wire tips
_ndmt
l!II
i$i
39 .....................................