JB256D JB480D JBS160D JBS360D JBS460D RBS360D

8 49-88075 Rev. 3
Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob in and turn in either direction to the
setting you want.
A surface ON indicator light will glow when any surface
unit is on
For glass cooktop surfaces:
A HOT COOKTOP indicator light will:
Ŷ FRPHRQZKHQWKHXQLWLVKRWWRWKHWRXFK
Ŷ VWD\RQHYHQDIWHUWKHXQLWLVWXUQHGRII
Ŷ VWD\RQXQWLOWKHXQLWLVFRROHGWR
approximately 150°F.
USING THE RANGE:6XUIDFH8QLWV
Surface Units
WARNING
FIRE HAZARD: Never leave the range unattended with the cooktop ON above a Lo setting. Keep
flammable items away from the cooktop. Turn off all controls when done cooking. Failure to follow
these instructions can result in fire, serious injury or death.
At both OFF and HI the control clicks into position. You may hear
slight clicking sounds during cooking, indicating the control is
maintaining your desired setting.
Be sure you turn the control knob to OFF when you finish cooking.
Coil Cooktops
Each coil surface unit uses "SENSI-TEMP
TECHNOLOGY" to reduce the risk of cooktop oil and
grease fires. This feature is located in the center of each
surface unit. Power to the surface unit is temporarily
interrupted when a pot or pan exceeds expected cooking
temperatures. Even after the surface units are turned off,
the surface unit retains enough heat to continue cooking.
To avoid overcooking, remove pans from the surface
units when the food is cooked. Avoid placing anything on
the surface unit until it has cooled completely.
Cookware for Coil Cooktops
The following information will help you choose cookware which will give good performance on coil cooktops.
NOTE: Follow all cookware manufacturer’s recommendations when using any type of cookware on the coil cooktop.
Recommended
Stainless Steel
Thin unclad stainless steel will give poor performance.
Aluminum
Heavy weight recommended.
Good conductivity. Because of its low melting point, thin
weight aluminum should not be used.
Copper Bottom
Enamel (painted) on Cast Iron
Cast Iron
Avoid/Not Recommended
Enamel (painted) on Steel
Glass-ceramic
Poor performance.
Stoneware
Poor performance.