Quick Specs

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
JK3800SH
GE
®
27" Built-In Combination Microwave Oven
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 11/18
Listed by
Underwriters
Laboratories
NOTE: Cabinets installed adjacent
to wall ovens must have an adhesion
spec of at least a 194°F temperature
rating.
INSTALL ATION INFORMATION:
Before installing, consult installation
instructions packed with product for
current dimensional data.
Door handle protrudes 3" from
door face. Cabinets and drawers on
adjacent 45° and 90° walls should be
placed to avoid interference with the
handle.
Electric wall ovens are not approved
for installation with a plug and
receptacle. They must be hard wired
in accordance with installation
instructions.
NOTE: These ovens are not
approved for stackable or side-by-
side installations.
23" MIN.
door opening
allowance
CONDUIT
48"
C
L
Suitable
bracing
to support
runners
(must support 275 lbs.)
2 x 4 or
equivalent runners
level with bottom of cutout
and flush with sides of cutout
or solid bottom floor.
B
27''
A
C
CUTOUT WIDTH
25" MIN.
25-1/4" MAX.
Recommended
minimum
cutout location
from the floor
21-5/8"
CUTOUT HEIGHT
41-1/8" MIN.
41-1/4" MAX.
JK3800
PK7800
24"
E
F
D
CABINET 27"
A –Overlap of oven at top of cutout 1"
B – Overlap of oven over side of edges of cutout 3/4"
C –Overlap of oven at bottom of cutout 1"
OVEN
D –Install depth 23-1/2"
E –Overall height with trim 42-3/8"
F –Overall width 26-3/4"
8-3/4" MAX.
RIGHT SIDE ONLY
CUTOUT DEPTH
23-1/2" MIN.
28" MIN. to
bottom of
junction box
Junction box
location
(Junction box
may be located
in adjacent
cabinet)
ATTENTION INSTALLER: All electric wall ovens must be hard-wired (direct-wired)
into an approved junction box. A plug and receptacle is NOT permitted on these products.
NOTE: If the cabinet does not have a solid bottom,
two braces or runners must be installed to support
the weight of the oven. For single ovens, the runners
and braces must support 200 lbs (91 kg). For double
ovens, the runners and braces must support 375 lbs.
(170 kg).
NOTE: If marks, blemishes or the cutout opening are
visible above the installed oven, it may be necessary
to add wood shims under the runners and front trim
until the marks or opening are covered.
NOTE: If the cabinet does not have a front frame
and the sides are less than 3/4" (1.9 cm) thick, shim
both sides equally to establish the cutout width.
KW RATING
240V 7.2
208V 5.4
BREAKER SIZE
240V 30 Amps
208V 30 Amps