Installation guide

Installation
Instructions
27" Built-In Wall Oven
JKP20, JKP25, JKP28, JKP48, JKP50, JK915,
JK955, JKS06, ZEK938, ZEK958
If you have questions, call 1.800.GE.CARES or visit our website at:
www.GEAppliances.com
Before You Begin
Read these instructions carefully and completely.
IMPORTANT-save these
instructions for local inspector's use.
IMPORTANT-observe a,
governing codes and ordinances.
Note to Installer--Be sure to leave these
instructions with the consumer.
Note to ConsumermKeep these
instructions for future reference,
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
NOTE--This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Parts Included
Screws for
Installation
Metal
Bottom Trim
Optional
Metal Bottom Trim
Plastic
Bottom Trim
Optional
Metal Bottom
Trim Assembly
(on some models)
Materials Needed
4__ _o WireNu_t S
Strain Relief Clamp Junction
for 1/2" conduit Box _£. _
36" of String
Tools Needed
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
220c4053P504-4
31-10523-4 06-04JR

Summary of content (16 pages)