Installation guide

Installation Instructions
IAICutoutfor30' 6.2cm)Double Built-InOvensonly
For JTP35, JTP55, JTP75, PT956, PT960, ZET958 models only.
Allow 11/16"
(1.75 cm) for
overlap of oven
over side edges
of cutout
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc, when
door is open
21" (53.3 cm)
Cutout
Width
28 112" (72.4 cm)
Min,
28 518" (72.7 cm)
==: Max.
Opening I
Between I
Inside Walls I
Must Be At
Least 28 1/2"
_,llow1" (2.5cm)
minimum for
overlap of oven
top and 1W"
(3.2 cm) overlap
of oven bottom
of cutout
Cabinet
Width
I
7 3/4"
(19.7 cm Junction Box Cabinet Width
) Location
(junction box Recommended
may be Cutout Location
located in
adjacent
cabinet)
/
-1
47" (119.4 cm)
Min.
to Bottom of
Junction Box
51 13/16" (131.6 cm)
Min.
51 15/16" (131.9 cm)
Max
i
Suitable
Bracing
to Support
Runners --
Recommended
cutout location
(30.5 cm)
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For
double ovens, the runners and braces
must support 275 Ibs (124 Kg).
from Floor
Cutout Depth
Cutout Width
Cutout Height
30" (76.2 cm)
12" (30.5 cm)
23 1/2" (59.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
51 13/16" (131.6 cm) Min.
51 15/16" (131.9 cm) Max.
NOTE: If the cabinet does not
have a front frame and the sides
are less than 3/4" (1.9 cm) thick,
shim both sides equally to
establish the cutout width.
-- 2" x 4"
(Scm x 10cm)
or equivalent
runners level
with bottom
of cutout
-_(54, 21 5/8"-------_
9 cm) Over \
Centerline
of Cabinet
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
10