Installation guide

ManualsBrandsGE ManualsWall oven/microwave comboOfficial GE microwave/double oven combo

Installation

nstruct=ons

27" Built In Wall Oven

W/Microwave

JKP85

"lf you have questions, call 800-GE-CARES orvisit our website at I

www.GEAppliances.com"

CAUTION: Before you begin- read these

instructions completely and carefully.

• IMPORTANT- Save these instructions for

local inspector's use.

• IMPORTANT-OBSERVEALL GOVERNING

CODES AND ORDINANCES.

• Note to Installer- Be sure to leave these

instructions with the Consumer.

• Note to Consumer- Keep these instructions

for future reference.

• Installation of this Built-In Wall Oven w/

Microwave requires basic mechanical and

electrical skills. Proper installation is the

responsibility of the installer. Product failure

due to improper installation is not covered

under the GE Applicance Warranty.

Parts Included

8 screws (double)

Bottom Trim

Materials Needed

[_r_ Wire N_uts

Junction _

Strain Relief Box

Clamp 36" of String

Tools You Will Need

1/8" Drill Bit & Phillips

Electric or Screwdriver

Hand Drill

Pub. No. 31-10462

229c4053P430 1

Summary of content (12 pages)

PAGE 1
27" Built In Wall Oven W/Microwave Installation nstruct=ons JKP85 "lf you have questions, call 800-GE-CARES www.GEAppliances.com" CAUTION: Before you begin- read these instructions completely and carefully. • IMPORTANTSave these instructions for or visit our website at • Note to Consumer- Keep these instructions for future reference. • Installation of this Built-In Wall Oven w/ local inspector's use. • IMPORTANT-OBSERVEALL GOVERNING CODES AND ORDINANCES.
PAGE 2
Installation Instructions IMPORTANT SFETY INSTRUCTIONS Electrical Requirements For Your Safety • Be sure your oven is installed properly by a qualified installer or service technician. • Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand or hang on the oven door.
PAGE 3
Installation Instructions Pre-Installation Remove packaging Checklist materials. E_ Remove the Oven Door Open the oven door to the stop broil position. Check inside microwave, behind hinges, and under false bottom. Remove labels on door, plastic on trims and panel, and all tape around oven. i[ Open oven door and remove literature prepack, broiler pan and grid, and oven racks. Open microwave door and remove shelves and turntable package.
PAGE 4
Installation [_ Pre-Installation [_" Instruction Checklist cont. Place the Oven on a Platform I_' Place the oven on a table or platform even with the cutout opening. (Platform must support 225 Ibs. ) Remove the Bottom Trim Remove the bottom trim from the top of the oven. It will be installed at the end of installation. The trim is wrapped separately and taped to the top of the unit.
PAGE 5
Installation Instructions Cutout for Built-In Oven W/Microwave JUNCTION BOX LOCATION CABINET Cabinet CUTOUT WIDTH 25" MIN. 25 1/4" MAX. Cutout Depth .23 1/2" Cutout Width ..25" .... CUTOUT 2" x 4" or _ equivalentt runners Allow a minimum of 20" for clearance to adjacent corners, drawers, walls, etc. when doors are open HEIGHT 41 1/8" MIN. MAX. _[ 25 1/4" Max. Cutout Height ........................ 41 1/8" Min. 41 1/4" Max. Overall 41 5/8" Height Overall Width ..
PAGE 6
Installation Instructions Electrical Connections New Construction and FourConductor Branch Circuit Connection Turn off the circuit breaker or remove fuses to the oven branch circuit. With the oven in front of the cabinet opening on a table or platform, connect the flexible conduit to the electrical junction box as shown below. You will need to purchase a strain relief clamp to complete the connection of the conduit to the junction box.
PAGE 7
Installation Instructions Electrical Connections Three-Conductor When connecting to a 3-conductor circuit, if local codes permit: cont Branch Circuit Connection branch NOTE TO ELECTRICIAN: The 3 power leads supplied with this appliance are UL recognized for connection to larger gauge household wiring. The insulation of these 3 leads is rated at temperatures much higher than the temperature rating of household wiring.
PAGE 8
Installation Instructions Placing the Oven In the Opening Sliding the Oven Into the Opening. Drilling the Pilot Holes a. Loop a 36" string around the conduit before the oven is slid into place. This will keep the conduit from falling behind the oven. NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it will go, and that it is centered. L Pull out on the string while pushing _ a.
PAGE 9
Installation Instructions _ Replacing the Oven Door Make sure the hinge is in the door stop position. The oven door is heavy. You may need help lifting the door high enough to slide it down onto the hinges. Do not lift the door by the handle. Remove the toweling or paper towel holder from the hinge. Grasp the door on both sides. Hold the door over the hinges aligning the hinges with the hinge slots on the bottom of the door. Slide the door down onto the hinges as far as it will go. I_1 Close the door.
PAGE 10
Installation Instruction PRE-TEST CHECK LIST Check that the bottom trim is installed Remove all protective film if present, and any stickers. _ properly (see page 7). checkt° be surethat a''w'rin° is Check to be sure the mounting screws are installed and flush with the side trim, (see page 7). secure and not pinched or in contact with moving parts. _ Operation Checklist [_ Remove all items from the inside of the oven. 1li_Vl Turn on the power to the oven. (Refer to your Use and Care Manual.
PAGE 11
NOTES 11
PAGE 12
NOTES Pub. No.