Installation guide

Installation Instructions
Placing the Oven In the Opening
Sliding the Oven Into the
Opening.
a. Loop a 36" string around the conduit before
the oven is slid into place. This will keep the
conduit from falling behind the oven.
L
Pull out on the
string while pushing
_ the oven into the
cabinet.
<:4
b. Lift oven into cabinet cutout using the oven
opening as an grip. Carefully push against
oven front frame. Do not push against out-
side edges.
c. As the oven is slid back, pull the string so
that the conduit will lie behind the oven in a
natural loop.
d. When you are sure the conduit is out of the
way, slide the oven 3/4 the way back into the
opening. Remove the string.
a. Slide the oven 3/4 way
into the cabinet cutout.
b. Attach the bottom trim to
the front frame with the 3
screws provided.
c. Slide the oven all the way
into the cabinet cutout.
Installing the Bottom Trim
Caution: Be sure you do not tip the oven
foward during installation or you may bend
the bottom trim. The bottom trim provides
an opening for cooling air to enter the
cabinet. This opening should never be
blocked.
Drilling the Pilot Holes
NOTE: Before drilling the pilot holes,
make sure the oven is pushed as far
back into the opening as it will go,
and that it is centered.
a. Drill four-I/8" pilot holes through the
mounting holes (top and bottom) of the
side trim, for the four #8 screws provided.
MOUNTING HOLE LOCATIONS
The screws must
be a minimum of
1/4" from the front
edge of the
cutout.
NOTE: Mounting screws must be
used. Failure to do so could result in
the oven falling out of the cabinet
causing serious injury.
i
b. Secure the Oven to Cabinet with screws
provided.
NOTE: If the cabinet is particle board, you
must use 4 #8 x 3/4" particle board screws.
These may be purchased at any hardware
store.
8