Installation guide

Installation Instructions
Cutout for Built-In Oven
with Microwave
Allow 7/8" for
overlap of oven
over side edges
Allow a minimum of 20"
for clearance to adjacent
corners, drawers, walls,
etc. when door is open
Cabinet
27"
Cutout
Width
25" Min.
25 1/4" Max.
2" x 4" or
equivalent
runners
level with
bottom
of cutout
Allow minimum
1" for overlap
of oven top and
bottom of cutout
Junction Box
Location
I
I
Cutout
Height 44"
Min. Above
41 1/4" Max. base rail
Alternate I
Junction Box
Location
Recommended
minimum cutout location
from floor 21 5/8"
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. The
runners and braces must support 255 Ibs.
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
Cabinet Width
Recommended
Minimum
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
27"
21 5/8"
23 112"
25" Min.
25 1/4" Max.
41 1/8" Min.
41 1/4" Max.
NOTE: If the cabinet does not
have a front frame and the
sides are less than 3/4" thick,
shim both sides equally to
establish the cutout width.
2" x 4" or equivalent
runners level with
bottom o1 cutout
I_'_ 18" _l
27" -_
NOTE: If using equivalent
runners, then the center of the
equivalent runners should be
20 1/2".