Installation guide

Installation Instructions
Preparing for the Bottom
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim
as a template,
mark the center
of each slot
(three total) where
the mounting holes
will be drilled.
c. Remove the trim.
d. Drill pilot holes into the
center of each template mark.
=
With Lower Trim
in Position, Mark _;111111lll
(3) Mounting Hole -_e.l_H'll
Locations -/-""-_.'4_.._
Lower Trim
Before
Pre-drilling
Mounting
Holes
I_] Installing the Bottom Trim
a. Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
b.
Trim Screws
Side Trim ....._ _ Metal Lower Trim
Using three trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
IMPORTANT: If this unit is ever
removed from the cabinet or the oven
is ever pulled out for service, the trim
must be removed first or damage to
the trim will occur.
_ CAUTION: Be sure you
do not tip the oven forward
during installation or you may
bend the bottom trim, The bottom trim
provides an opening for cooling air to
enter the cabinet, This opening should
never be blocked,
9