Manual

ManualsBrandsGE ManualsRange hoodOfficial GE range accessory

Use and Care of Recirculation Hood Model JN327

and Ventilating Hood Models JV327, JV337 & JV347

IMPORTANT SAFETY

INSTRUCTIONS

READ AND SAVE THESE

INSTRUCTIONS.

WARNING--TO REDUCE THE RISK

OF FIRE. ELECTRIC SHOCK OR

INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

A. Use this unit only in the manner intended

by the manufacturer. If you have any questions.

contact the manufacturer.

B. Installation work and electrical wiring must be

done bv qualified person(s) in accordance with

all applicable codes and standards, including

fire-rated construction.

C. When cutting or drilling into wall or ceiling,

do not damage electrical wiring and other

hidden utilities.

D. Ducted fans must always be vented to

the outdoors.

E. If this unit is to be installed over a tub or

shower, it must be marked as appropriate

for the application.

B. Before servicing or cleaning unit. switch WARNING--To reduce the risk of fire,

power offat service panel and lock the service use only metal ductwork.

disconnecting means to prevent power from

being switched on accidentally When the service When using your hood...

• Never leave surface units unattended at high

disconnecting means cannot be locked, securely

fasten a prominent warning device, such as a settmgs. Boilover causes smoking and greasy

tag, to the service panel

CAUTION: For general ventilating use only. Do

not use to exhaust hazardous or explosive

materials and vapors.

When you get your new hood...

• Have it installed and properly grounded by a

qualified technician in accordance with the

installation instructions

• Have the installer show you the location of

the hood circuit breaker or fuse and mark it for

easy reference.

• Take the time to read our suggestions for best use.

spillovers that may ignite and spread if hood is

used. Use surface umt heat settings recommended

by the manufacturer and adequate-size utensils.

• Never use your cooking appliance for warming

or heating the room. The electrical wiring of your

range hood may not withstand the resulting

excessive heat.

. Keep the hood clean and clean grease filter or

replace combination filter as recommended to

maintain good venting and to avoid grease fires.

WARNING--TO REDUCE THE RISK

OF A RANGE TOP GREASE FIRE:

A. Keep fan. filters and grease laden

WARNING--TO REDUCE THE RISK surfaces clean

OF FIRE. ELECTRIC SHOCK OR

INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

A. The combustionairflowneededfor safe

operation of fuel-burning equipment may be

affected by this unit s operation. Follow the

heating eqtupment manufacturer's guideline and

B. Always turn hood ON when cooking

at high heat.

C. Use high range settings on range only

when necessary. Heat oil slowly on low

to medium setting.

D. Don't leave range unattended when cooking.

safety standards such as those published by the E. Alwavs use cookware and utensils appropriate

National Fire Protection Association (NFPA), for the type and amount of food being prepared.

and the American Society for Heating

Refrigeration and Air Conditioning Engineers • When flaming foods under the hood, turn the fan on.

_ASHRAE). and the local code authorities. ,co,n,,,ed _e.,_t;_,g_j

Turn the page for Operation and Maintenance instructions.

GE Quality Product

Summary of content (12 pages)

PAGE 1
Use and Care of Recirculation and Ventilating Hood Models Hood Model JN327 JV327, JV337 & JV347 IMPORTANT SAFETY INSTRUCTIONS B. Installation work and electrical wiring must be done bv qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. READ AND SAVE THESE INSTRUCTIONS. WARNING--TO REDUCE THE RISK OF FIRE. ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: C.
PAGE 2
If You Need Service... IMPORTANT SAFETY INSTRUCTIONS lcontmued_ WARNING--TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: • Do not attempt to repair or replace any part of your hood unless it is specifically recommended in this book. All other servicing should be referred to a qualified technician • Disconnect performing Models: hood circuit breaker any service. or fuse before JN327 & JV347 non-ducted I (ModeI JV347 has a lamp cover.) A.
PAGE 3
To Operate Grease F /_ I])i_ Fan switch Lamp Switch Vents (JN327 & JV347) \ tt11!!!1155555!!!111 Lamp switch Models: JN327, JV327, JV337 Press for OFF and ON. Lamp Switch Filter "JV" models only The efficiency of your hood depends on a clean filter. Frequency of cleaning depends on the type of cooking you do. BUT GREASE FILTER SHOULD BE CLEANED AT LEAST ONCE A MONTH. NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE. To remove: Pull down on the center of the front edge of the filter.
PAGE 4
Installation Instructions for General Electric Hood WARNING---TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. OBSERVE THE FOLLOWING: _ppty connection box on underside of hood. A. Installation work and electrical wiring must be done by qualified persons(s) in accordance with all applicable codes and standards, including fire-rated construction. B.
PAGE 5
1. PREPARATION AND WALL OF WALL CABINET FLUSH OR RECESSED BOTTOM CABINET NOTE: For easier installation make all hood and vent cutouts in the cabinet and wall before cabinet is permanently fastened in place. It is recommended that the power supply be brought into the hood from the wall below the cabinet as shown in Fig. 1. However, an optional location is shown in Fig. 2, where the power supply enters the top of the hood by passing through the wall cabinet. A.
PAGE 6
Models JV337, JV347 Total Model JV347 ducted installation: Remove the charcoal pad from the filter. Remove the baffle from the top of the hood. Re-install the baffle so the short side marked "VENTED" is visible. The long side of the baffle should be inside the hood. The hood has been designed to mate with a standard x 10" rectangular or 7" diameter round duct. Duct Pieces Equivalent Length 6" round, straight Number Used 5 feet 2.
PAGE 7
3. POWER SUPPLY A. CIRCUIT VOLTAGE: This hood must be connected to a supply circuit of the proper voltage and frequency as specified on the rating plate. Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for hoods of this rating. The rating plate is located on the rear wall of the hood. B. FUSE RATING: Centerline of hood 15 amps. C.
PAGE 8
B. ELECTRICAL CONNECTION Wire nuts 1. Be sure making 2. Remove left side the power supply is disconnected before electrical connections. the connection box cover located on the of the fan unit. 3. Attach the power supply through in the back or top of the hood. the knockout ,Colored White leads hole 4. Connect the colored incoming power supply lead to the stripped black lead and connect the incoming white neutral lead to the stripped white lead in the connection box as shown in Figs. 12 and 13.
PAGE 9
Lamp Remove the lamp and replace with an ordinary screwbase lamp bulb NOT MORE THAN 60 WATTS. Replacement Model JV347 has a lamp cover. The lamp cover need not be removed or installation. for lamp removal CAUTION: Let the lamp cool completely before removing. A warm or hot bulb may break if touched with a moist cloth or hand. To remove the lamp cover, if desired: • Press the sides with 2 fingers until the side prongs are released. • Lift the lamp cover and slide towards you in one motion.
PAGE 10
Questions? Use This Problem Solver PROBLEM POSSIBLE CAUSE I FAN DOES NOT OPERATE WHEN THE SWITCH IS ON , • A fuse may be blown or a circuit breaker AIR fuse or reset circuit breaker. i FAN FAILS TO CIRCULATE tripped. Replace • Fan blade striking the hood shell. I • Excessively soiled filter should be checked and corrected before using the hood again. I FAN OPERATES BUT MOVES AIR SLOWER THAN NORMAL FAN KEEPS GOING OFF AND ON Check to be sure the Filter is clean.
PAGE 11
Help Us Help You... If You Need Service Write down the model and serial numbers. To obtain service, see your warranty page of this guide. You'll find them on a label on the back wall of the hood. These numbers are also on the Consumer Product Ownership Registration Card that came with your hood. Before sending in this card, please write these numbers here: We're proud of our service and want you to be pleased.
PAGE 12
Staple sales slip or cancelled check here. Proof of original purchase date is needed to obtain service under warranty. YOUR RANGEHOOD WARRANTY WHAT IS COVERED FULL ONE-YEAR WARRANTY For one year from date of original purchase, we will provide, free of charge, parts and service labor in your home to repair or replace any part of the hood that fails because of a manufacturing defect.