Installation Instructions

13
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and a
cutout large enough for the exhaust adaptor.
CHECK BLOWER MOTOR
ORIENTATION
The blower fan blade opening should be facing the top
of the microwave. If the fan opening is already facing
the top of the microwave, skip to Step A5. Otherwise,
continue to Step A4 to adjust the motor orientation.
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
Remove and save the screws that hold the blower
motor to the microwave oven.
Remove and save the metal blower shield on the top
of the microwave by sliding it right.
ADAPTING BLOWER FOR
OUTSIDE VENTILATION (Cont.)
Attached the metal blower shield to the backside of
the microwave oven by sliding it down.
Open the blower door by lifting it up at the back of
the microwave oven.
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
5ROOWKHEORZHUXQLWÛVRWKDWWKHIDQEODGH
openings are facing the top.
A2.
A3.
A4.
A4.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
Wear safety goggles when drilling
holes in the cabinet bottom.
Installation Instructions
1
3
4
5
6
2
Back of Oven
Blower Motor
Screws
Blower Plate
BEFORE: Fan Blade
Openings Facing
Forward
AFTER: Fan Blade
Openings Facing
Up
Blower
Shield
Roll
NOTE: Make
sure wires
remain routed
in the grooves
of the motor
frame.
Blower Motor
Screw