Installation Guide

4
31-2000912 Rev. 0
Installation Instructions
Printed in the United States
INSTALLING OVEN
To remove the oven door:
1. Open the door to the stop position (see Fig. 3A).
2. Grasp the door at each side and lift up and off the
hinges (see Fig. 3B).
CAUTION
When the door is removed and
hinge arms are at stop position, do not bump or try
to move the hinge arms. The hinges could snap back
causing an injury to the hands or damage to the
porcelain on the front of the range. Cover the hinges
with toweling or empty towel rolls while working in the
oven area.
3. Put the oven into the cabinet and use a 1/8” drill
bit to drill holes in the cabinet front through the
holes in the oven trim.
4. Secure the oven in the cabinet with the screws
provided.
5. The lower trim should be mounted to the bottom of
the oven frame with the 3 screws provided.
The lower front trim is packed separately and should
be added after the oven is installed. The oven door
must be removed to install the lower trim.
IMPORTANT: The trim provides cooling air entry
into cabinet through the bottom opening. The bottom
opening should never be blocked. See Fig. 3B.
REPLACE THE OVEN DOOR
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
2. Slide the door down onto the hinges as far as it
will go and close the door.
Stop Position
Fig. 3A Fig. 3B
Hinge