Specifications Sheet

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
JRP20SK
GE Appliances 24" Built-In Single Oven
Listed by
Underwriters
Laboratories
Specification Revised 1/16
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
NOTE: The wall coverings, countertop and cabinets
around the oven should be able to withstand the heat
(up to 200°F) generated by the oven. It is important that
the oven be installed at or above the minimum height
specified. The unit has been tested and approved, in
accordance with safety standards, at this height. This
model is NOT approved for side-by-side installation.
INSTALL ATION INFORMATION: Before installing,
consult installation instructions packed with product for
current dimensional data.
KW RATING
240V 3.4
208V 2.6
BREAKER SIZE
20 Amps†
†Check local codes for required
breaker size.
Oven JRP20
A - Overall depth 25-1/8"
B - Overall height with trim 28-1/4"
C - Overall width 23-3/4"
C
L
2 x 4 or
equivalent runners
level with bottom of cutout
and flush with sides of cutout
or solid bottom floor
Suitable
bracing to
support
runners
(must support 90 lbs)
23-1/2" MIN.
20"
22-1/2" MIN.
Conduit 48-1/2"
32-1/2"
27-5/8" MIN.
10"
24"
Allow 7/8"
for overlap
over all edges
of cutout
Locate
junction box
either 5" MAX.
below cutout
floor or 23-7/8"
MIN. above
cutout floor
Minimum
cutout location
from floor
A
C
B