Use and Care Manual

16
Safety Instructions
Operating Instructions
Care and CleaningTroubleshooting TipsConsumer Support
Before you call for service…
Troubleshooting Tips
Problem Possible Causes What To Do
Oven temperature too Oven thermostat See the Adjust the oven thermostat—Do it yourself!
hot or too cold needs adjustment. section.
Oven will not work A fuse in your home may Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
Oven controls improperly set. See the Using the oven section.
“F— and a number You have a function Touch the CLEAR/OFF pad. Allow the oven to cool for
or letter” flash error code. one hour. Put the oven back into operation.
in the display
If the function code Disconnect all power to the oven for at least 30
repeats. seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may be Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. Reset the clock.
Unable to get the Oven control pads were not The BAKE and BROIL HI/LO pads must be touched at
display to show “SF” pressed properly. the same time and held for 3 seconds.
Power outage, Power outage or surge. Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
Strong odor An odor from the insulation This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.