Manual

2. Attach the damper/duct connector.

#8-1 8 x 318"

ELECTRICAL

KNOCKOUTS

FRONT

OF HOOD

Use two (2) screws (provided) to attach the connector

to the housing. The damper flap should open in the

direction indicated by the arrow.

3. Remove the electrical knockout.

Choose either the top or side of the housing for the

electrical cable entrance. Remove the appropriate

knockout.

4. Set the housing into the opening.

SLIDE

Carefully lower the housing into the cabinet opening

with the slide control to the front

5. Remove the access cover.

ACCESS

COVER

6. Open the filter )and.

VISOR

SLIDES

Pull the visor slides out. Rotate the panel clips

and swing the panel open.

7. Install the mounting brackets.

INSTA_R

Insert the bent end of the installation rod into the

access hole in the housing.

BRACKET

Choose the mounting bracket with the center hole.

Hang the bracket from the rod, through this center

hole, as shown. Pull the bracket up between the

cabinet and housing.

#8-18 x 2"

#8-1 8 x 1"

INSERT

SCREWS

HERE

Hold the mounting bracket in place with the rod. Two

sets of screws are provided. Use the short screws for

flush bottom cabinets or the long screws for recessed

bottom cabinets. Insert two (2) screws through the

housing and into the mounting bracket. Do not tighten

the screws completely.