Installation guide

Installation Instructions

CHECK MICROWAVE ASSEMBLY

Exhaust Adaptor (absent

on models shipped for

recirculation exhaust)

Backof

• Place the microwave in its upright position, with the

top of the unit facing up.

• The microwave oven may be shipped assembled for

top exhaust (adaptor installed) or for recirculation

exhaust (adaptor absent).

• If the microwave was shipped for recirculafion

exhaust, skip to (;5. If shipped for top exhaust,

proceed with (;4.

ADAPTING MICROWAVE

BLOWER FOR RECIRCULATION

[] Remove . _ Denper [] I,ifl off the

and save , blower plate

screw that and attached

holds blower" adaptor from

plate to the microwave.

microwave. [

Backof

_-- Microwave "

_ Slide exhaust adaptor to one side and remove it.

NOTE: The exhaust adaptor with damper is not

needed for recirculating models. You may want to

save them for possible furore use.

_ Remove and the that holds the blower

save screw

motor to the microwave.

_ BlowerPlate

_11_ Backof

€_ _- Microwave

11_ "----. _. BlowerMotor

""q_-- Screw

_ Careflflly pull out the blower unit. The wires

will extend far enough to allow you to adjust the

blower unit.

_Roll the blower unit 90 ° so that fan blade openings

are facing toward the flont of the microwave.

R011

NOTE: Make sure wires remain routed in the

grooves of the motor flame.