Installation guide

Installation Instructions

OUTSIDE TOP EXHAUST (Vertical Duct)

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall

A2. Prepare Top Cabinet

A3. Check Damper Operation

A4. Mount Microwave Oven

A5. A(!just Exhaust Adaptor i

A6. Connect Ductwork

ATTACH THE MOUNTING

PLATE TO THE WALL

Attach tile plate to tile wall using toggle bolts.

At least one wood screw IlltlSt be used to attach

tile plate to a wall stud.

[]Remove tile toggle wings fl'om tile bolts.

[]Insert the bolts into the mounting plate

through the holes designated to go into drwvall

and reattach the toggle wings to _A" onto each bolt.

To use toggle bolts:

Spacingfor Toggles

MoreThanWall

+l..-.[.--Th ckness

ToggleWings

Mounting

Plate

BoltEnd

_ Place tile mounting plate against tile wall and

insert tile toggle wings into tile holes in tile wall

to mount tile plate.

NOTE: Betore tightening toggle bolts and wood

scre_, make sure tile tabs on tile mounting plate

touch the bottom of the cabinet when pushed

flush against the wall and that the plate is properly

centered under the cabinet,

CAUTION: Be careflfl to axoid I)inching, finoers,_

between the back of the mounting plate and the wall,

_ Tighten all bolts, Pull the plate awax from the wall

to help tighten the bolts,