Installation guide

Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes fl)r the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enom, h_ fi_r the exhaust adaptor.
%
" Read tile instructions on tile TOP CABINET
TEMPLATE.
" Tape it tmderneath tile top cabinet.
" Drill tile holes, fl_llowing tile instructions on tile
TOP CABINET TEMPLATE.
CAUTION: X,\'ear salety goggles when drilling holes
in tile cabinet bottom.
CHECK FOR PROPER
DAMPER OPERATION
BlowerPlate
ExhaustAdaptor
(absenton modelsshipped
for recirculationexhaust)
Backof
Microwave
" Place tile microwave in its upright position, with tile
top of tile unit thcing up.
* This microwave oven may be shil)ped assembled for
top exhaust (adaptor installed) or fi_r recirculation
exhaust (adaptor absent).
o Make sure tape securing damper is removed mid
damper pivots easily before mounting microwave.
* You will need to make a(!justments to assure proper
alignment with your house exhaust duct after tile
microwave is installed.
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTAI,IATION AND PERSONAl,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use tile nvhm
grommet around tile power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet fl'ont hangs below tile cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When mo/mting
tile u/icrowave oven,
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling cord.
_I,ifl tilt it
iuicrowave,
flwward, and hook
slots at back bottom
edge onto l()/lI" lower
tabs of mounting
_Rotate front of
o_en
up against cabinet
bottoul.
_lnsert a selt:aligning screw through top center
cabinet hole. Temporarily secure the oven bv
turning tile screw at least two full turns after tile
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especiaJly
when mounting flush to bottom of cabinet.
13