Installation guide

Installation Instructions
[-_ ATTACH THE MOUNTING
,%,================_
PLATE TO THE WALL
i
I
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
[]Remove the toggle wings fron/ the bolts.
[]Insert the bolts into the mom_ting plate through
the holes designated to go into drywall and reatmch
the toggle wings to :_A"onto each bolt.
To use toggle bolts:
Mounting
Plate
Spacingfor TogglesMore
-,_l-,,-,,.!_._ThanWall Thickness
i
ToggleWings
BoltEnd
_ Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
scrm_, make sure the tabs on the mortaring plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to axoid I)inchin("_ fingers
between the back of the motmting, I)late and the wall.
_ Tighten all bolts. Pull the fl'om the wall
plate
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enouoh for the power cord to fit throu ,h
%
" Read the instructions on the TOP CABINET
TEM PI,ATE.
" Tape it tmderneath the top cabinet.
" Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: _4ear safet} goggles when drilling holes
in the cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[] Remoxe and that holds blower
sa'_e sci'ew illOtOi"
to i/lie i'owa_, e.
BlowerMotor
"" "_L-__...._ Blower Motor
Screw
_ Careflflly the blower trait. The wirespull
(HIt
will extend far enough to allow _ou to a(!just the
blower unit.
EndB
End
16