Installation guide

Installation Instructions
RECIRCULATING INo.-Ve.tedDuctlessl
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Check Microwave Assembly
C4. A(!just Blower
C5. Mount the Microwave ()veil
C6. Install Charcoal Filter
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
[]Remove the toggle wings from the bolts.
_ Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to _A" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+F_.-[.--Th ckness
ToggleWings
Mounting
Plate_
BoltEnd
[]Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make stlre the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflll to avoid I)inching, fingers,
between the back of the mounting plate and the wall.
_ Tighten all bolts. Pull the plate awm from the wall
to help tighten the bolts.
| USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enouoh for the power cord to fit throuoh
" Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it underneath the top cabinet.
" Drill the holes, tollowing the instiuctions on the
TOP CABINET TEMPLATE.
CAUTION: X._'ear satety goggles when drilling holes
in the cabinet bottom.
19