Installation guide

Installation Instructions

CHECK MICROWAVE ASSEMBLY

Exhaust Adaptor (absent

on models shipped for

recirculation exhaust

Backof

Microwave ;

" Place tile microwave in its upright position, with tile

top of tile unit lacing up.

* Tile microwave oven may be shipped assembled fin,

top exhaust (adaptor installed) or fin" recirculation

exhaust (adaptor absent).

* If tile microwave was shipped for recirculation

exhaust, skip to (;5. If shipped fi_r top exhaust,

proceed with C4.

ADAPTING MICROWAVE

BLOWER FOR RECIRCULATION

[] Remoxe _ D_riper [] I,ift off tile

and saxe , blower plate

screw that .... and attached

holds blower" adaptor from

plate to tile microwaxe.

i/licrowa', e. !

ackof

........ ,'"'"'"' _-- Microwave

[]Slide exhaust adaptor to one side and remove it.

NOTE: The exhaust adaptor with damper is not

needed for recirculating models. You mav want to

save theln for possible ftlttlre rise.

_ Remove and tile that holds tile blower

save scFew

ii/otor to tile illicrowa'_e.

_ BlowerPlate

_.___ Backof

<_ _ Microwave

_ Carefully pull out tile blower trait. Tile wires

will extend tar enouoh_ to allow _ou to adjust tile

blower trait.

_Roll tile blower trait 90 ° that tim blade I)enings

so o

are tacing toward tile front of tile inicrowaxe.

R011

NOTE: Make sure wires remain routed in tile

gi'oo_,es of the i/lotor fraille,