Installation guide

Installation Instructions
| ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
[]Place the blower unit back into the
)ening.
o
I
CAUTION: Do not pull or stretch the blower refit
wiring. Make sure the wires are not pinched.
[]Secure blower unit to microwaxe with the screw
remoxed in Step 4.
[]Replace blower plate with the screw remoxed in
Step 1.
T
!
_-qr- Backof
Microwave
MOUNT THE MICROWAVE
OVEN
FOIl EASIER INSTAI,IATION AND PERSONAI,
SAFETY, X4'E RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If vom" cabinet is metal, use the nylon
grommet arotmd the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet fl'ont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE: When motmting
the illicrowave oven,
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do [] I,ifl microwaxe, tilt it
not pinch cord or lift
oxen b) )ullin,, cord. _ fi)rward, and hook
l _ slots at back bottom
edge onto four lower
tabs of motmting
_ Rotate front of oxen
up against cabinet
bottolll.
_lnsert a sell=aligning screw through top center
cabinet hole. Temporarily secure the oven by
tm'ning the screw at least two full turns atter the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
Equivalentto Depth
f CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
_Attach the microwaxe oxen to the top cabinet.
21