Installation guide

Installation Instructions

I- PLACEMENT OF THE MOUNTING PLATE

I'_ REMOVING THE MICROWAVE

OVEN FROM THE CARTON/

REMOVING THE MOUNTING

PLATE

_ Remove the installation instructions, filters, glass

tray and the small hardware bag. Do not remove

the Swroioam protecting the fl'ont of the oven.

[] Fold back all 4 carton flaps flflly against carton

sides. Then careflflly roll the oven and carton over

onto the top side. The oven should be resting in

the Stvrofi)am.

_Pull the carton up and off the oven.

[] Remove and properly discard plastic bags

[]Remove the 2 screws from the mounting )late

, } •

This plate will be used as the rear wall template

and for mounting. You max discard these screws.

I-_ FINDING THE WALL STUDS

i i Wall i

(enter

_Find the studs, using one of the following

methods:

A. Stud finder - a magnetic device which

locates nails.

B. Use a hammer to tap lightly across the

mounting surthce to find a solid sound.

This will indicate a stud location.

_ After the stud find the by

locating

(s),

centel"

probing the wall with a small nail to find the edges

of the stud. Then place a mark hal_\vay between

the edges. Tile center of any ac!jacent studs should

be 16" or 24" fl'om this mark.

_Draw a line down the center of tile studs.

THE MICROWAVE MUST BE CONNECTED TO

AT LE&ST ONE WALL STUD.