Installation Instruction

Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
1
6
5
ADAPTING BLOWER FOR
RECIRCULATION
(continued)
C3.
21
Replace blower plate and replace screws for blower
plate and blower motor removed in Step 1.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Oven Top
Equivalent to Depth
of Cabinet Recess
Installation Instructions
2
Rotate front of oven up
against cabinet
bottom.
MOUNT THE OVEN
C4.
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent cutting
of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening
screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
Self-Aligning Screw
Blower Plate
Back of
Oven
Blower Plate Screws
Blower Motor Screw