Installation Guide

6 31-10983-5
Installation Instructions
PREPARE THE WALL
Hood Body
1. Putaprotectivecoveringoverthesurfacebelow
thelocationofthehoodtoprotectfromdirtand/or
damage.
2. Determineandmarkthecenterlineonthewall(draw
lineuptotheceiling)wheretherangehoodwillbe
installed.Basedontheceilingheight,determinethe
distance24”requiredmin,38”recommendedmax
(X)neededbetweenthecookingsurface(B)andthe
bottomofthehood.Tothisdistance,add7”anddraw
ahorizontalline(A)about24”longcenteredonthe
verticalcenterline(C).
3. Mark2pointsoneachsideofthehorizontalline(A),
5-1/2”fromtheverticalcenterline(C).Drillthecanopy
mountinganchorsintothewallatthemarkings.Install
the2mountingscrewsintotheanchors,leavinga
1/4”gapbetweenthewallandthebackofthescrew
head.(Youwillplacethehoodbodyontothesescrew
heads.)
4. Drawasecondhorizontalline(D)thatis1-1/4”added
fromtheXdistance.Drawathirdhorizontalline(E)
thatis4-5/16”addedfromtheXdistance.
5. Mark2pointsoneachsideofthehorizontalline(D),
7-7/8”fromtheverticalcenterline(C).Drillthe2holes
forinstallationwitha9/32”drillbit,andinserttheduct
coveranchors.
6. Determineandmarkwheretheholewillbedrilledfor
thepowersupplycabletoberunthroughthewall.
Markapointontheleftsideofthehorizontalline(E),
6-1/4”fromtheverticalcenterline(C).Drilla1-1/4”
holeatthismark.
Duct Covers and Power Supply
1. Placeoneoftheductcoverbracketsagainstthe
wallsothatitstopedgeis1/16”fromtheceilingand
level.Alignthecenternotchesofthebracketandthe
centerline(C)andmarkthecentersofthebracket
holes.Removethebrackettodrillthe2holesfor
installationwitha9/32”drillbit,andinserttheduct
coveranchors.Placethebracketbackonthewall
andinstallthe2mountingscrewsintotheanchors.
Tightenscrews.
2. Placetheotherductcoverbracketonthewallso
thatitstopedgeis10-1/2”fromtheceilingandlevel.
Alignthecenternotchesofthebracketandthe
centerline(C)andmarkthecentersofthebracket
holes.Removethebrackettodrillthe2holesfor
installationwitha9/32”drillbit,andinserttheduct
coveranchors.Placethebracketbackonthewall
andinstallthe2mountingscrewsintotheanchors.
Tightenscrews.
1-1/4
"
4-5/16"
6-1/4"
7"
X
5-1/2" 5-1/2"
A
E
D
C
B
7-7/8" 7-7/8"
C
1/16"
Ceiling
10-1/2
"