Installation Guide

2 31-11120-1
Installation Instructions
CONNECTION METHOD FOR JVX3240 AND JVX3300
PARTS NEEDED
■ 2-Position and 3-Position wall switches.
■ Electrical wire to connect to wall switch in accordance
with local codes.
■ Wire nuts. Use appropriate wire nuts for size of the
electrical wire.
■ 18 gage white wire.
MOTOR
C30 DX
0
3
BLK
1
ORG
2
VLT
1
GREY
WHT
PINK
ORG
1
VLT VLT
3
RED
RED
OFF
1
WHT
2
WHT
BLK
BLK
BLK
LINE
120Vac
60Hz
HOOD INTERNAL CONTROL
WHT
2
WHT
LAMP
VLT
MOTOR
C30 DX
0
3
BLK
HOOD EXTERNAL CONTROL
ORG
1 2
VLT
1
ORG
1
VLT
RED
OFF
WHT WHT
BLK
BLK
LINE
120Vac
60Hz
WHT
2
WHT VLT
LAMP
EXTERNAL
CONTROL
COM S2
G
S1
SPEED2
SPEED1
CONTROL
L
LIGHT
CONTROL
LIGHT LIGHT
L
WIRING
BOX
GREY
WHT
PINK
WIRING
BOX
3 1 2
MOTOR
This connection method allows full control of the range hood using wall switches. However, the rocker switch on the
range hood will be disconnected if this method is used for connection of range hood to wall switch.
Step 1: To establish connection of hood fan to wall
switch, locate the hood junction box and remove its cover.
Step 2: Disconnect the pink wire in the junction box
coming from the motor from the red wire coming from
3-position rocker switch on the range hood. Cap the red
wire coming from 3-position rocker using appropriate
size wire nut.
Step 3: Connect the pink wire in the junction box
coming from the motor to a 3-position wall switch. This
will allow control of high fan speed.
Step 4: Disconnect the grey wire in the junction box
coming from the motor from the black wire coming
from 3-position rocker switch on the range hood. Cap
the black wire coming from 3-position rocker using
appropriate size wire nut.
Step 5: Connect the grey wire in the junction box
coming from the motor to a 3-position wall switch. This
will allow control of low fan speed.
Step 6: Connect a black wire from hot on 3 position wall
switch for fan to the black hot wire in the junction box.
Step 7: Disconnect the orange wire in the junction box
from the white wire coming from the motor and cap the
orange wire using appropriate size wire nut.
Step 8: Connect an 18 gage white wire to the white wire
coming from the motor using appropriate size wire nut
at one end. At the other end connect the 18 gage white
wire to the neutral white wire in the junction box using
appropriate size wire nut.
Step 9: To establish connection of hood lights to wall
switch, connect a black wire from hot on 2 position wall
switch for light to the black hot wire in the junction box.
Step 10: Disconnect the violet wire in the junction box
coming from the lamps from the violet wire coming
from 2 position rocker switch on the range hood. Cap
the violet wire coming from 2 position rocker using
appropriate size wire nut.
Step 11: Connect the violet wire in the junction box
coming from the lamps to the 2 position wall switch.
Step 12: Re-install the junction box cover using the
screws.
Wiring Diagram 991.0438.344
Before getting started, check the wiring diagram number on your hood to make sure
these install instructions apply to your model